How To
Apply Solid Gel Nail Polish
- Trim and buff your nails.
- Apply one coat of Ambedo Base Coat onto your nails.
- Cure nails under the Ambedo LED Nail Lamp for 60-90 seconds
- Apply one coat of your chosen Solid Nail Gel Colour from the palette using the applicator brush on your nails.
- Cure nails under the LED Lamp for another 60-90 seconds (Optional: For a richer colour, apply a second coat of colour and cure for 60-90 seconds).
- Apply one coat of Ambedo Top Coat over the cured nail colour and cure under the LED Lamp for 60-90 seconds.
Tip 1: apply a THIN coat of solid gel to get optimal results! Remember that you can add more coats after curing each time.
Tip 2: Want to add extra strength and even less chance of chipping? Apply and cure a second layer of Top Coat over the first layer of Top Coat.
Apply Bio-based Nail Glue
For more frequently asked questions please check out our FAQs
Remove Gels
- Buff away your gel polish to remove the protective top coat
- Open a foil sachet up and place your nail inside the foil
- Wrap the foil around your finger
- Repeat the process with your other nails and leave the foils on for around 10 minutes
- Remove any residual polish using a cuticle pusher
NOTE: Any acetone-based remover can be used to remove our gels.
Brush Preparation
- Apply a small amount of Ambedo Stronger With You Base Coat to a flat surface (ie. a small dish etc)
- Coat your cleaned nail brush by dipping it in the base coat until all the bristles are covered
- Dip the nail brush into your chosen Solid Gel colour. A small amount on each side of the brush
- Apply to your nails and see how easy it is to get an even layer!
Brush Cleaning
- After using the brush or when swapping to another gel colour, use rubbing alcohol or the alcohol pads provided in the nail care set to wipe away any residual gel.
- Acetone-based removers can also be used to remove the residual gels.
- Make sure you put your brush away somewhere safe (AKA in your palette) so that it does not collect dust until your next nail sesh!